Weft-beating Movement-Weft beating mechanism common faults on the impact of knitting quality

Industrial Reed Wire Mesh Weaving Loom Spare Parts New Condition Product Heald Wire Loom Machine Reed

1. The female connection between the reed seat foot 

and the lower shaft of the reed is loose, causing the 

seat to tremble. When weaving the net, the weft 

filaments are prone to thin channels.

2. The connecting shaft on each connecting rod of 

the drawbar is worn out, or the nut on each 

connecting shaft is loose, causing the seat to chatter. 

After stopping the loom and then starting it again, 

the weft wire will appear serious thin road. Weaving 

light grade square hole mesh, the weft wire mesh 

hole will appear a large and small pair of eye-like 

serious uneven.

3. Loose connecting bolts between the reed seat base 

plate and the reed seat support, and loose connecting 

bolts between the reed seat support and the reed 

seat foot, which cause the reed seat to tremble, 

resulting in uneven density of the weft filaments, 

especially after stopping and then starting the loom, 

and the weft filaments are prone to thinning.

4. The excessive or uneven pressure of the reed seat 

on the reed causes deformation of the reed blade, 

resulting in extra-large mesh holes.

5. The reeds are not straight or individual reeds are 

protruding, causing the sword belt to run unstably.

6. The action of the tight reed plug iron (inclined 

iron) on the reed is not uniform, the reed is 

deformed in the place where it is stuck tightly, 

and the reed flutters in the place where it is stuck 

loosely, which seriously shortens the service life 

of the reed.