The Precautions in Warping Process of Warping Machine and Prevention of Common Defects You Should Know

Before Warping Starting

1. Please check the accuracy and reliability of the counter. While 

handing over the shift, the first warp should be finished. Please 

prepare another one and the counter should be reset to zero.

2. Check the machine work well or not before warping. Whether 

the gear will slip, observe the number of teeth supported by the 

cone is equal each time, and remove the fault in time. 

When The Warp Beam Turns Around

the distance the bracket moves must be greater than the diameter 

of the warping wire to prevent the edge from collapsing due to 

small slope. If the wire are found to collapse during warping, 

paraffin can be applied to the collapsed edges. Do not increase 

the warping tension arbitrarily. 

After Finishing A Handful of Wire

the cone mechanism should be restored before moving. 

In Warping 

Please confirm the same number of turns, and don’t 

change the number of wires per handle and the width 

on the positioning reed arbitrarily.

And if the wire is broken, you can conect it by hands.