sales@apmwiremeshmachine.com+86-311-66792193/66792197
The sword belt guiding plate plays the role of blocking plate, which mainly prevents the sword head from touching the reed when it is running. The installation position of the blade guide plate should be parallel to the reed. Adjustment method: loosen the upper fastening screw on the sector gear, so that the tie rod and the sword plate sector gear disengagement, manual sword plate a swing lever, so that the sword belt for high-speed back and forth movement, observe whether the sword head touches the right end of the reed, if the touch breaks into the reed, then we must forward to adjust the position of the sword belt guiding plate, so that the sword belt guiding plate and the reed is parallel. Line. If the sword head moves to the left to the right end of the reed, it does not touch the reed and leaves the reed surface (0.5mm). If the sword head moves to the right end of the reed to the left without touching the reed and leaves the surface of the reed (0.2-0.5) mm, and the sword head moves back to the right without touching the guide plate of the sword belt, then the adjustment is correct. Then connect the drawbar with the sector gear.
The adjustment position of the guide rail should be adjusted according to the position of the fencing board, the installation height of the guide rail should be higher than the fencing board (2~3) mm, and its orientation should be parallel to the fencing board.
The installation height of the sword plate should be adjusted according to the height of the guide rail, the sword belt must enter the guide rail according to the direction of the tangent of the sword plate, and it should not be lower than the guide rail, otherwise the sword belt is easy to wear out, the noise is big, and the head of the sword is easy to punch out of the mesh surface.