Monthly Archives: September 2016

Healding &Reeding   1.Definition Healding: Warp wire through the heddle in a certain rules Reeding : Warp wire through the reed in a certain order   2.Preparatory Work 1) According to the task, you need to get suitable heddles with straight and smooth. Putting the heddles perfectly on the heald frame,in the meantime,you need calculate […]

The calculate of technological parameter   1).L: the length of warp wire L=L₁+L₂ L₁:the length of the mesh you will produce L₂:the length of the consumption,about 4-6m 2). M: the total number of the wire M=Mesh×[Mesh Width(mm) ÷25.4mm] 3). N: the number of turns of warping N=L÷πD ² D:the diameter of warp beam 4). B: […]

The reasons of common defects and prevent method   A. Cross wire Reasons analysis 1),The width of reed is equal or greater than the width of provision. 2),Some fault on conic mechanism, for example every time when the number of gear turn is not same or gear slip. 3),After warp one handful the distance is […]

3.Warping machine working process Warp wire motion track Spool→Plastic reed→Wire guide roller→Lease reed→Tension rods→Reed→Warp beam 1),According to the warping specification, prepare the Lease reed、Reed、Warp beam。 2),To determine the distance from the conic mechanism to the right when the warp beam takes a turn. To determine the turn’s number of warping and the width of yarn […]

Before weaving mesh preparation (warping, healding &reeding) 1.Definition 2. Preparatory Work 3.Process 4. Notes and Solution 5.Calculation Introduction from five points. A certain number and length of warp wire compose the yarn sheet. Warp wire twines the warp beam with uniform tension and parallel and compactness. The purpose of warping is preparing for weaving mesh. […]